Welds metal components together with resistant welding equipment to fabricate or repair products such as machine parts, plant equipment, motors, and generators by performing the following duties.
Essential duties and responsibilities include the following:
Welds metal parts together using resistant projector welding processes.
Positions and clamps together components of fabricated metal products
Compares workpiece with sample part to verify conformance to specifications.
To perform this job successfully an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill and /or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential duties.
Education and/or experience:
Less than high school education with up to three months related experience or training
Ability to read and comprehend simple instructions and effectively present information in a one on one and small group situations to other employees.
Ability to add, subtract, multiply and divide in all units of measure, using whole numbers, common fractions, and decimals.
Ability to apply common sense understanding to carry out detailed but involved written or oral instructions and to deal with problems involving a few concrete variables in standardized situations.
While performing the duties of this job the employee is regularly required to stand, walk, sit, stoop, squat and reach, grasp, push and pull using arms and legs. The employee must regularly lift and/or move up to 10 pounds, frequently lift and/or move up to 25 pounds, and occasionally lift and/or move up to 50 pounds. Specific vision abilities required by this job include the ability to adjust focus.
The work environment characteristics describes here are representative of those an employee encounters while performing the essential functions of this job. The noise level and air quality are usually moderate. The employee will encounter hydraulic and other oils as well and various types of metal components. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
Sleeveless tops, halter tops or tank tops.
Ripped, frayed, stained or messy
Approved dress code:
T-shirts (no graphics).
Navy, Black or Work Jeans (must be long pants in ALL areas)
Company logo wear.
This job description does not list all the duties of the job. You may be asked by management to perform other duties. Industrial Fabricators Inc. has the right to revise this job description at any time.
**Department Hours are subject to change based on customer demands! ** Employees in this department should be prepared as hours change and can do so by request of the plant manager due to customer demands**.
General Hours 1st shift (8 hours) 7am – 3:30pm, (10 hours) 7am – 5:30pm
General Hours 2nd shift (8 hours 3:30pm – 12am, (10 hours) 5:30pm – 4am
(1/5/2021) Effective Immediately:
ALL PLANTS WILL BE ON THE BREAK SAME SCHEDULE
1st Shift: 10-minute break @ 9:00 am, 30-minute Lunch break @ 12:00 pm
2nd Shift : 10 minute break @ 5:30, 30 minute break @830
Overtime and weekends are required when requested by our department manager, plant manager, due to customer demand. We have been known to work Monday – Sunday. This department does not typically work Sundays, but they can ask should a customer or our production drive us to need to do so.